←Back to Dashboard
← Toolbox Library
SERNEM Toolbox● Ready8–10 MINUTES

OXY-FUEL TORCH AND FLASHBACK PREVENTION TOOLBOX TALK

Prevent flashback, gas leaks and torch-related fire.

Cylinders, regulators, hoses, torch, flashback protection and ignition.

Checking account…
← Back to Toolbox Library

Preview is public. A free SERNEM account is required to download the standard PDF.

Toolbox Topic

OXY-FUEL TORCH AND FLASHBACK PREVENTION TOOLBOX TALK

Duration

8–10 MINUTES

Date

Site / Area

Supervisor

Company

Participants

Document No

OBJECTIVE

✓

Prevent flashback, gas leaks, hose fires and pressure-related injuries during oxy-fuel cutting and welding.

TOPIC EXPLANATION

✓

Incorrect gas pressure, blocked tips, damaged hoses or unsuitable equipment can lead to flashback and flame travel into a gas system.

✓

Flashback arrestors, check valves and other protective devices must suit the equipment and manufacturer instructions. Inspect the torch, hoses, connections and regulators before use.

✓

Keep oxygen equipment free of oil and grease. Never use an open flame to locate a gas leak.

REALISTIC SITE SCENARIO

✓

A cutting crew continued with a damaged hose and did not inspect the torch tip.

✓

Unusual flame behaviour and noise developed during cutting, but work was not immediately stopped.

✓

Suitable flashback protection, inspection and manufacturer-approved emergency shutdown could have reduced the risk.

REMEMBER

✓

Stop for gas leaks or abnormal flame behaviour and follow the equipment manufacturer's safe shutdown and isolation procedure.

KEY HAZARDS

✓

Flame flashback into torch or hoses.

✓

Gas leakage and fire.

✓

Violent ignition involving oxygen contamination.

✓

Regulator damage or unsuitable pressure.

✓

Slag damage to hoses.

✓

Cylinder impact or overturning.

✓

Gas accumulation in confined areas.

✓

Sparks reaching combustible materials.

CONTROL MEASURES

✓

Verify hot-work permits and area controls.

✓

Secure cylinders in their approved position.

✓

Use regulators, hoses and torches rated for each gas.

✓

Inspect approved flashback and reverse-flow protection.

✓

Check hoses, valves and joints before use.

✓

Keep oxygen fittings free from oils and grease.

✓

Use an approved safe gas-leak check method.

✓

Protect combustibles from sparks and hot slag.

✓

Stop for abnormal flame, sound or leaks and shut down safely.

✓

Check cylinder valves and hose condition after work.

SUPERVISOR TALKING SCRIPT

✓

Before cutting, we check flashback protection, torch, hoses and regulators. Never check gas leaks with a flame. Any abnormal sound or flame means stop and follow safe shutdown.

DISCUSSION QUESTIONS

✓

Where is the flashback arrestor?

✓

Are regulators and hoses sound?

✓

How will leaks be checked?

✓

Are combustibles protected?

✓

What is the emergency shutdown procedure?

PRE-WORK VERIFICATION

✓

Hot-work permit approved

✓

Cylinders secured

✓

Regulators suitable

✓

Hoses intact

✓

Flashback protection checked

✓

Oxygen fittings oil-free

✓

Leak check completed

✓

Fire controls in place

✓

Emergency stop understood

✓

Crew briefed

ATTENDANCE AND APPROVAL

✓

Project / Site

✓

Date

✓

Presented by

✓

Work area

Attendance and Signature

#NamePositionSignature
1
2
3
4
5
6
7
8
9
10
11
12

Supervisor Signature

HSE Approval

SERNEM HSE Resource — Task-specific risk assessment, authorised procedures, manufacturer instructions and local law take precedence.